Rigging
Instructions
for the
Trinka 10 Sailing Dinghy
-
The longest line
(38') is the halyard. Secure halyard to the head of the
sail.
Note: Halyard should be set up prior to stepping the mast.
-
The next longest
line (30') is the sheet. The sheet runs from the bottom
eye on the boom end fitting, down through the traveler block,
back up to the first block on the boom, then forward through the
next block on the boom, then down to the swivel block on the aft
side of the daggerboard trunk.
-
The third longest
line (66") is the outhaul. Tie the outhaul to the clew on
the sail, and run it through the block on the end of the boom,
and foward to the cam cleat on the boom.
-
The fourth
longest line (60") is the traveler. Secure the traveler
through holes in the quarter knees, with figure "8" knots.
(Be sure to feed it through the traveler block first).
-
The shortest line
(36") is the downhaul. Secure the downhaul to the bottom
of hook, and tie down to clear on mast. (Make sure the
hook is upward).
|
|
